R5 SOLID AIS System
OPERATION
7000 118-200, C2 Page 39
4.4.15 Main Menu Config Interface Miscellaneous
Changes the value of the SSD password level. When
set to “None”, no password is required when
configuring the transponder with an SSD sentence from
e.g. an ECDIS via the serial port interface.
When set to “User”, an SPW sentence with the correct
user level password must be sent before the SSD on
the serial port interface.
This affects how the user should input the ship size,
convoy size and antenna positions. See section 4.4.4
for more details.
Defines on which serial port the R5 SOLID should
output data from the internal GPS. When set to “None”
no internal GPS data will be output.
This parameter specifies if there is a blue sign switch or
silent switch connected to the orange and brown wires
of the R5 SOLID Power Cable.
If no switch is used, set the parameter to “No Function”.
See sections 3.7.7 and 3.7.8 for more information
about the blue sign switch and silent switch.
This parameter determines if an ACK msg is required
as a response when sending addressed binary text
messages to another target.
4.4.16 Main Menu Config System Settings
Determines if the R5 SOLID should operate as a Class
A transponder or as an Inland transponder. This
parameter affects which config parameters and menus
that are visible in the system.
This parameter determines the unit for the range value
of targets in the Target List, Extended Info view and
Plot view. The range value can be calculated in nautical
mile (NM), kilometre (km) or statute mile (Sm).
This parameter determines the unit for the SOG value
of targets in Extended Info view and Plot view. The
SOG values can be calculated in knots (kn), kilometres
per hour (km/h) or miles per hour (mph).
This parameter determines how the plot of AIS targets
To Next Page
Loading...
