Saeco D.A. COMBISNACK - Page 46

46
English
MOTORI GUASTI
07
OPERATION METHOD DISPLAY MESSAGE
Accessing the error log Use theMaintenance/ERROR LOG ERROR LOG
menu Mxx Eyy dd/mmm hh:mm
Mxx = number of the spiral motor to which the error refers
Eyy = error code
dd = day of the month
mmm = month
hh = hour
mm = minute
Use “+” and “-“ to scroll the list.
Erasing the error log Enter the error list and press the Actually, the log will not be erased, the VM will display only
beverage button 9 the information stored after this operation, instead
Viewing all the information Enter the error list and press the The VM will display again all the information
(including erased information) beverage button 5
Getting the total number of stored Press the snack buttons “1” and SAECO COMBI SAECO
errors (with the VM in the standard “3” simultaneously XXX yyy zzz
operation mode)
Note
Any error or anomaly is stored, except blocks (coffee block,
soluble block, beverage block, and water block)
- Washing
It allows to rinse the dispensing circuits of the soluble
products.
Pressing the ENTER key the automatic cycle starts,
thus activating in sequence each soluble circuit.
Recommended solutions
To wash the circuit of a single soluble you need to keep the
beverage keys pressed:
- Beverage A key: soluble 1 wash
- Beverage B key: soluble 2 wash
- Beverage C key: soluble 3 wash
- Beverage D key: soluble 4 wash
- Boiler emptying
It enables starting the automatic boiler discharging
cycle.
MOTOR CHECK
Through this function a diagnostics is displayed of all active
motors. It is then possible to test each or all the motors in
sequence.
- Motor failures:
The digit shown in the second line (example “07”)
indicates the number of motor failures in the spirals.
By pressing ENTER key, you enter the entries
identifying both faults and error of motors. (See table
on page 44).
This error can be cancelled by pressing ENTER again
within these entries. The vending machine actuates the
motor and try to time it. If the operation is successful,
the error number is reset. Otherwise, check the cause
of the failure on the out-of-service message table
(11.2).
- Single motor
Enables scrolling the list of motors to carry out a test
on a single motor.
The second line indicates the condition of the motor.
- Sequence of motors
Allows you to carry out an automatic performance
test on all motors. Through this function, the vending
machine will actuate in sequence all spiral motors.
In case a motor should be faulty timed, the v.m. will
turn it until it reaches the correct position.
Important
After every fault reset, a check of the motor showing a
trouble must be done.