4-005
How to Use Fault Diagnosis Flow Chart
・
As a result of checking, if YES line or NO line directly goes to the description in the CAUSE
column, take necessary action as indicated in the REMEDY column.
・
Under each box (□) are standard value and condition necessary for diagnosis procedure. If
the result gives an affirmative answer to the question adressed in the box or agrees with the
value indicated under the box, then go to YES line. Otherwise, go to NO line.
・
The standard values have been taken from the standard value list.
・
For the location of component parts such as relays mentioned in the flow chart, see the
drawing which shows the location of key units. The line colors mentioned in the flow charts
are indicated in the electric wiring diagram shown under the flow chart. In the actual machine,
each wire is also identified by color.
To Next Page
Loading...
