84 • Program Mode Programming ER-260/265 Electronic Cash Register AU
Customer Logo Descriptor
Without otherwise programming, the customer logo will print a two line message at the top of each
receipt:
___
_
THANK_YOU
___CALL_AGAIN
If you wish you can replace this message with your own custom message. Your message can be up
to 6 lines long. (see “Alpha Program Overlay”)
Programming a Custom Logo:
1. Turn the control lock to the PGM position.
2. Press the X/TIME key.
3. Enter up to 32 characters for a line of the logo
* For EPROM v1.013A and after, refer to NEW Alpha Overlay, enter the character
you wish, or
* For EPROM v1.010 and before, refer to OLD Alpha Overlay, enter the character
you wish, each character follow up with decimal point ‘•’, or
* Refer to the Code Table, enter the two digits that represent each character you
wish.
4. Press the X/TIME key.
5. Enter the two digit number that represents the line of the message you wish to program:
Line#
Code
Line Content
Line#
Code
Line Content
11 1
st
Line Preamble Logo 21 1
st
Line Postamble Logo
12 2
nd
Line Preamble Logo 22 2
nd
Line Postamble Logo
13 3
rd
Line Preamble Logo 23 3
rd
Line Postamble Logo
14 4
th
Line Preamble Logo 24 4
th
Line Postamble Logo
15 5
th
Line Preamble Logo 25 5
th
Line Postamble Logo
16 6
th
Line Preamble Logo 26 6
th
Line Postamble Logo
6. Press the CHECK key
7. Repeat from step 2 to 6 for each line you are programming.
8. Press the CASH/TEND key to end programming.
To Next Page
Loading...
