Samsung BD-D7500 - Warning

Safety Information
Warning
LASER PRODUCT
LASER PRODUKT
LASER LAITE
LASER APPARAT
LASER CLASE 1
The explanation point within the triangle
is a warning sign alerting you of important
instructions accompanying the product.
CLASS 1
KLASSE 1
LUOKAN 1
KLASS 1
PRODUCTO
~ NOTE
• If the Region number of a Blu-ray Disc/DVDs does
not correspond to the Region number of this player,
the player cannot play the disc.
This Compact Disc player is classified as a CLASS
1 LASER product. Use of controls, adjustments
or performance of procedures other than those
specified
herein may result in hazardous radiation
exposure.
Complies with
21 CFR 1040.10 except for
deviations pursuant to
Laser Notice No. 50, dated
June
24, 2007.
DANGER:
• VISIBLE AND INVISIBLE LASER RADIATION
WHEN OPEN. AVOID DIRECT EXPOSURE TO
BEAM. (FDA 21 CFR)
CAUTION:
• CLASS 3B VISIBLE AND INVISIBLE LASER
RADIATION WHEN OPEN. AVOID EXPOSURE
TO THE BEAM (IEC 60825-1)
•
THIS PRODUCT UTILIZES A LASER. USE
OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION
EXPOSURE. DO NOT OPEN COVER AND DO
NOT REPAIR YOURSELF. REFER SERVICING
TO QUALIFIED PERSONNEL.
CLASS 1 LASER PRODUCT
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lighting flash and Arrowhead within the
triangle is a warning sign alerting you of
dangerous voltage inside the product.
FCC NOTE (for U.S.A)
• To reduce the risk of fire or electric shock, do
not expose this appliance to
rain or moisture.
This equipment has been tested and found to
comply
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against
harmful interference in a residential
installation.
This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions,
may cause harmful interference
to
radio or television reception, which can be
determined by turning the equipment off and on.
The user is encouraged to try to correct the
interference by one or more of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect this equipment into an outlet on a
circuit different from that to which
the receiver is
connected.
• Consult
the dealer or an experienced radiofTV
technician for
help.
• This class B digital product meets all
requirements of the Canadian Interference -
Causing Equipment Regulations.
Note to CATV system installer
This reminder is provided to call CATV system
installer's attention to Article 820-40 of the
National Electrical Code (Section 54 of Canadian
Electrical Code, Part I) that provides guidelines
for proper grounding
and, in particular, specifies
that
the cable ground shall be connected to the
grounding
system of the building as close to the
point of cable entry
as practical.
WARNING
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK).
NO USER-SERVICEABLE PARTS ARE INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
English 3