Santec TSL-770 - Page 32

5-16
TSL-770 Operation Manual
The current wavelength is displayed at
λ
curr
intherstlineduringsweepoperation.An
indicator showing the sweep progress is displayed on the bottom line.
4. Multiple sweep operations
Touch REPEAT to execute repeat operations:
Sweep Mode
：
Changes the wavelength continuously following the set sweep speed.
Step Mode:
Sets the wavelength in sequence following the set wavelength step and
dwell time.
IfCycleissetto0(zero),numberofrepeattimesisinnite.TouchSTOPtostop
operation.Thecurrentwavelengthisdisplayedatλ
curr
intherstlineduringsweep
operation. Indicators showing the progress of the sweep and the completed
number of sweeps are displayed at the bottom. The display of the number of
sweeps returns to 0 after 999.
NOTE