Sanyo PLC-WU3800 Service Manual

-36-
Electrical Adjustments
Group/
Item
Item Name Function Initial Range Note
Group
41
Deinterlacer setting
Effective only for Progressive Mode 1, Film mode.
0
Motion Adaptive Weight
Value
<KDEINT> 30/30/30 0 - 255 Group 1:Composite/S-video
1 Angle Interpolation Level
0 : Conservative <====> 4 :
Aggressive
4/4/4 0 - 5 Group 2:Composite/Scart/PC
2 CUE Low Pass Filter Enable <CUELPFEN> 0/0/0 0 -255 Group 3:HDMI
Group
42
Deinterlacer setting
Effective only for Progressive Mode2 mode.
0
Motion Adaptive Weight
Value
<KDEINT> 0/0/0 0 - 255 Group 1:Composite/S-video
1 Angle Interpolation Level
0 : Conservative <====> 4 :
Aggressive
2/2/2 0 - 5 Group 2:Composite/Scart/PC
2 CUE Low Pass Filter Enable <CUELPFEN> 0/0/0 0 - 255 Group 3:HDMI
Group
47
Noise Reduction (Time)
Effective only for N.R L1
0 Noise Pixel Range <NSRANGEY> / <NSRANGEUV> 1 0 - 2
1 Noise Region 0
<NSREGIONY0> /
<NSREGIONUV0>
12 0 - 1023
2 Noise Region 1
<NSREGIONY1> /
<NSREGIONUV1>
24 0 - 1023
3 Noise Region 2
<NSREGIONY2> /
<NSREGIONUV2>
40 0 - 1023
4 Noise Gain Level <NSFILTERY**> / <NSFILTERUV**> 100 0 - 255
Group
49
Noise Reduction (Time)
Effective only for N.R L2
0 Noise Pixel Range <NSRANGEY> / <NSRANGEUV> 1 0 - 2
1 Noise Region 0
<NSREGIONY0> /
<NSREGIONUV0>
12 0 - 1023
2 Noise Region 1
<NSREGIONY1> /
<NSREGIONUV1>
24 0 - 1023
3 Noise Region 2
<NSREGIONY2> /
<NSREGIONUV2>
40 0 - 1023
4 Noise Gain Level <NSFILTERY**> / <NSFILTERUV**> 100 0 - 255
Group
50
2:2pull down setting
0 22Film Mode Sensitivity
Film Detection Sensitivity
<FILMSTVT22>
4 1 - 5
1 22Film Mode Threshold Low <FILMTHRD22A> 80 0 - 1023
2 22Film Mode Threshold High <FILMTHRD22B> 120 0 - 1023
3
Video Motion Window Start
X
<VOFSTARX> 10 0 - 255 Range of detective for Film mode
4
Video Motion Window Stop
X
<VOFSTOPX> 10 0 - 255 Range of detective for Film mode
5
Video Motion Window Start
Y
<VOFSTARY> 10 0 - 255 Range of detective for Film mode
6 Video Motion Window Stop <VOFSTOPY> 10 0 - 255 Range of detective for Film mode
Y
Group
51
2:3pull down setting
0 Global Motion Sensitivity
Film Detection Sensitivity
<FILMSTVT23>
4 1 - 5
1 Video Motion Sensitivity
Film Detection Sensitivity
<VOFSTVT>
4 1 - 5
2 Video Motion Threshold Low <VOFTHRDA> 120 0 - 1023
3
Video Motion Threshold
High
<VOFTHRDB> 180 0 - 1023
4
Global Motion 23Film
Threshold
<FILMTHRD23> 100 0 - 1023
5 Global Motion Window Start X <GMDSTARX> 10 0 - 255 Range of detective for Film mode
6 Global Motion Window Stop X <GMDSTOPX> 10 0 - 255 Range of detective for Film mode
7 Global Motion Window Start Y <GMDSTARY> 10 0 - 255 Range of detective for Film mode
8 Global Motion Window Stop Y <GMDSTOPY> 10 0 - 255 Range of detective for Film mode
Group
55
LTI /CTI
0 Video Enhancement Enable VEHEN 1 0 - 1
0 Video Enhancement Enable VEHEN 1 0 - 1
1 DLTI Gain DLTIGAIN 3 0 - 15
2 DLTI Frequency DLTIFREQ 2 0 - 3
3 Bypass Anti-Alias Filter DTIBYPASSAAL 0 0 - 1

Sanyo PLC-WU3800 Specifications

General

Matrix size	0.59 \
Projection distance	0.99 - 12.1 m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	40 - 300 \
Projector native resolution	WXGA (1280x800)
Keystone correction, vertical	±40 °
Audio input	2
Aspect ratio	16:10
Network ready	Yes
Power supply type	AC
Dimensions (WxDxH)	335.7 x 257.5 x 93.6 mm
Connectivity technology	Wired
Focus	Manual
Digital zoom	16 x
Focal length range	19.2 - 30.2 mm
Noise level	35 dB
Noise level (economic mode)	31 dB
Dot clock scanning frequency	140 MHz
Lamp type	NSHA
Lamp power	275 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3000 h
DVI port	No
Composite video in	-
Serial interface type	RS-232
USB 2.0 ports quantity	0
Supported video modes	1080i, 1080p, 720p
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL M, PAL N, SECAM
Supported graphics resolutions	1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 800 (WXGA), 1400 x 1050 (SXGA+), 1600 x 1200 (UXGA), 1920 x 1200 (WUXGA), 640 x 480 (VGA), 800 x 600 (SVGA)
Product color	White
AC input voltage	100 - 240 V
Power consumption (standby)	0.7 W
Power consumption (typical)	317 W
Power consumption (PowerSave)	280 W
Cables included	VGA

Weight and Dimensions

Depth	257.5 mm
Width	335.7 mm
Height	93.6 mm
Weight	3500 g