Sanyo PLC-WU3800 - Computer Input; Input Source Selection (Computer 1)

28
Choose Computer 1 by pressing the INPUT button on the top control or press the COMPUTER 1 button on the
remote control.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB / Component / RGB(Scart) )
Computer Input
P
Note:
When the Input Search function is set to On1 or On2 in
the Auto setup function, the input signal will be searched
automatically (p.46).
Computer
1
Top Control
INPUT button
Direct Operation
Menu Operation
Press the MENU button to display the On-Screen
Menu. Use the Point  buttons to select Input and
then press the Point  or the SELECT button.
Use the Point  buttons to select Computer 1 and
then press the Point  button to access the submenu
items.
When Computer 1 is selected, use the Point 
buttons to select RGB and then press the SELECT
button.
COMPUTER 1 button
Remote Control
Computer 1(RGB)
Computer 1(Scart)
Computer 1
HDMI
Computer 2⁄
S-video
Video
⁄
COMPUTER 2 can not be selected when using the COMPUTER IN 2/
MONITOR OUT terminal as MONITOR OUT output.