Sanyo PLC-WU3800 - Computer Input; Input Source Selection (Computer 2)

29
Computer Input
Choose Computer 2 by pressing the INPUT button on the top control or press the COMPUTER 2 button on the
remote control.
Input Source Selection (Computer 2: RGB)
Direct Operation
Menu Operation
P
Note:
When the Input Search function is set to On1 or On2,
the input signal will be searched automatically (p.46).
1
2
3
Press the MENU button to display the On-Screen
Menu. Use the Point  buttons to select Input and
then press the Point  or the SELECT button.
Use the Point  buttons to select Computer 2 and
then press the SELECT button.
When Computer 2 is selected, analog RGB input
source will be selected directly.
Input Menu
Top Control
INPUT button
Computer 1
HDMI
Computer 2⁄
S-video
COMPUTER 2 button
Remote Control
Computer 2 (RGB) ⁄
Video
⁄
COMPUTER 2 can not be selected when using the COMPUTER IN 2/
MONITOR OUT terminal as MONITOR OUT output.