Sanyo PLC-WU3800 - Information; Input Source Information Display

61
Input Source Information Display
The Information Menu is used for checking the status of the image signal being projected and the operation of
the projector.
H-sync freq.
V-sync freq.
Lamp counter
Information Menu
The horizontal frequency of the input signal is displayed in
KHz or - - - - - when no signal.
The vertical frequency of the input signal is displayed in Hz
or - - - - - when no signal. Numbers of Hz doubles when
during Interlace.
The cumulative lamp operating time is displayed.
Direct Operation
Press the INFO. button on the remote control to display the
Information Menu.
INFO. button
Remote Control
Press the Point  buttons to select Information. The
Information Menu is displayed.
See below for displayed information.
Menu Operation
Power management
Screen
Off , Ready , Shut down or Timer is displayed.
The selected screen size is displayed.
Input
Lamp status
The selected input source is displayed.
The selected lamp mode is displayed.
Information
Language
The selected language is displayed.
Key lock
The selected Key lock icon is displayed.
PIN code lock
Off , On 1 or On 2 is displayed.
Remote control
The selected remote code is displayed.