46
Setting
P
Note:
• Auto Keystone corrects vertical distortion only, not
correct horizontal distortion.
• The Auto Keystone function cannot work when the
Ceiling feature is set On in the Setting menu (p.51).
• Perfect correction of the image distortion cannot
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SETUP button, adjust manually by pressing
the KEYSTONE button on the remote control or
selecting Keystone in the Setting menu (pp.24,47).
• Fine sync, Total dots, Horizontal and Vertical
position of some computers cannot be fully adjusted
with the Auto PC adjustment function. When the
image is not provided properly with this operation,
manual adjustments are required (pp.32-33).
Auto setup
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point
buttons to select one of the following options.
Off ......Input search will not work.
On1 ....Input search works under the following situation.
– When pressing the AUTO SETUP button on
the top control.
– When pressing the AUTO SET button on the
remote control.
On2 ....Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the AUTO SET button on the
remote control.
– When pressing the AUTO SETUP button on
the top control.
– When the current input signal is cut off.*
* If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen menu is displayed.
Auto PC adj.
On . . . . . . Enables Auto PC adjustment when pressing
the AUTO SET button on the remote
control or the AUTO SETUP button
on the top control.
Off . . . . . . Disables Auto PC adjustment.
Auto Keystone
Auto . . . . Always works and corrects keystone
distortion according to the projector's tilt.
Manual . . Works only when pressing the AUTO SETUP
button on the top control or the AUTO SET
button on the remote control.
Off . . . . . . Disables Auto Keystone.
Auto setup
P
Note:
•While Input search is set to On1 or On2, the status of Input
and Lamp are displayed every time the signal is switched.
•Only the last selected input source can be detected.
•If the INPUT button on the top control or the HDMI,
COMPUTER, S-VIDEO or VIDEO buttons on the remote
control is pressed during Input search is in progress, Input
search will stop and go back to the previous input signal.
•Input search, Auto PC adj. and Auto Keystone cannot be set
Off at the same time.
This function enables Input search, Auto Keystone correction
and Auto PC adjustment by pressing the AUTO SETUP button
on the top control or the AUTO SET button on the remote
control. Settings for those functions can be altered as follows:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
