Sanyo PLC-WXU700 - Page 56

55
Setting
Picture in Picture
Thisfunctionisusedtoprojecttwovideossimultaneously
byplacingaseparatesmallsubscreenwithinthemain
screen.(PictureinPicturecombinationsprovidedinthis
projectorareshownonpages78.)
Onlythesoundonthemainpictureisheard,thesound
onthesubpicturecannotbeheard.(InP in P,thebig
pictureismainpicture,andthesmalloneissubpicture;inP
by P,theleftpictureismainpicture,andtherightoneissub
picture.)
Mode.....P in P :Thesubpictureinthemainpicture.
P by P:Thesubpicturebythemainpicture.
Off :ExitthePictureinPicturemenu.
Subpicture size...Selectthesubpicturedisplaysize.
Subpicturecanbechanged
betweenLarge, SmallandMiddle.
Subpicture position. .Setapositionforsubpicture.This
functionisusedtosetSubpicture
positionasfollows:
thetopleft→thebottomleft→
thebottomright→thetopright→
•••
Selecting the Main picture or Sub picture
DuringPictureinPicturemode,andnooperationontheOn
ScreenMenu,presstheSELECTbuttontoselectmainor
subpicture.(Whenthesubpictureisselected,aredframe
willbedisplayed.)
Switching of the Input Source
Inthemainpictureorthesubpicturemode,chooseinput
soure bypressingtheINPUTbuttononthetopcontrolor
pressingtheCOMPUTER、VIDEO、HDMIorNETWORK
buttonontheremotecontrolorthroughInputMenu
operation.
Operation of the Sub picture
InPictureinPicturemode,presstheSELECTbuttonto
selectthesubpicture(theframebecomestored),and
thenusethePoint▲▼◄►buttonstochangeSubpicture
size,swicththeMainpictureandtheSubpicture,andmove
Subpictureposition.
•InPictureinPicturemode,pressthePoint▲buttonto
switchtheMainpictureandtheSubpicture.
•InPinP,pressthePoint▼buttontochangeSubpicture
size.
•InPinP,pressthePoint◄►buttonstomove
Subpictureposition.
Picture in Picture
Note:
•Whentheinputsignal(s)is/areincompatible,Xmarkwill
bedisplayedontheMain/Subpicture.
•Whenthesubpictureissettothesamesignalasthemain
picture,Xmarkwillbedisplayed.
•Subpicture positionandSubpicture sizeareonlyused
forP in P.
Subpicture size
Note:
•WhenP in PorP by Pisset,Total dots is
disabledinthePCadjustmenu.
•InPictureinPicturemode,theFreezefunction
isdisabled.
•DuringPictureinPicturemodeandtheMenu
screenisdisplayed,viatheremotecontrol
operation,thesefunctionsaredisabledas
below:
•ChangeSubpicturesize.
•MoveSubpictureposition.
•SwicthingoftheMainpictureandSubpicture.
•SelecttheSubpicturemodebytheSELECT
button.