Sanyo PLC-XU115 - Basic Operation; Turning On the Projector

22
16
Thepreparationdisplaywilldisappear
after30seconds.
(Seepage53forLampcontrolstatus.)
Lampcontrolstatus
Turning On the Projector
Connect the projector’sAC power cord into an AC
outlet.ThePOWERindicatorlightsred. Openthelens
cap(seepages10,60).
Press the POWER ON/SYAND-BY button on the top
controlorontheremotecontrol.ThePOWERindicator
lightsgreenandthecoolingfansstarttooperate.The
preparation display appears on the screen and the
countdownstarts.
2
3
1
4
Afterthecountdown,theinputsourcethatwasselected
thelasttimeandthelampcontrolstatusicon(seepage
53)appearonthescreen.
If the projector is locked with a PIN code, PIN code
input dialog box will appear. Enter the PIN code as
instructedbelow.
Complete peripheral connections (with a computer,
VCR,etc.)beforeturningontheprojector.
What is PIN code?
PIN (Personal Identification Number) code is a security
code that allows the person who knows it to operate the
projector.Setting a PIN codepreventsunauthorizeduseof
theprojector.
APINcodeconsistsofafour-digitnumber.RefertothePIN
codelockfunctionintheSettingMenuonpages54–55for
lockingoperationoftheprojectorwithyourPINcode.
Enter a PIN code
Use the Point ▲▼ buttons to enter a number. Press the
Point ► button to fix the number and move the red frame
pointertothenextbox.Thenumberchangesto“.”Ifyou
fixedanincorrectnumber,usethePoint◄button to move
the pointer to the number you want to correct, and then
enterthecorrectnumber.
Repeatthissteptocompleteenteringafour-digitnumber.
After entering the four-digit number, move the pointer to
“Set.” Press the SELECT button so that you can start to
operatetheprojector.
If you entered an incorrect PIN code, “PIN code” and the
number (  ) will turn red for a moment. Enter the
correctPINcodealloveragain.
CAUTION ON HANDLING PIN CODE
IfyouforgetyourPINcode,theprojectorcanno
longer be started. Takea special care in setting
a new PIN code; write down the number in a
column on page 76 of this manual and keep it
at hand. Should the PINcode be missing or
forgotten,consultyourdealerorservicecenter.
Selected Input Source and Lamp Control
AftertheOKicondisappears,
youcanoperatetheprojector.
PIN Code Input Dialog Box
Notes:
 •When the Logo select function is set to
“Off,” the logo will not be shown on the
screen(p.50).
 •When the “Countdown off” or “Off” is
selected in the Display function, the
countdownwillnotbeshownonthescreen
(p.48).
 •Duringthecountdownperiod,alloperations
areinvalid.
 •If the correct PIN code number is not
entered within three minutes after the PIN
codedialogboxappeared,theprojectorwill
beturnedoffautomatically.
 •The“1234” isset asthe initialPIN codeat
thefactory.
 •When the Input Search function is set to
“On2”, the input signal will be searched
automatically(p.51)
Note:
 •The Filter warning and Lamp replacement
iconsmayappearonthescreendepending
ontheusagestateoftheprojector.
Basic Operation
Downloaded From projector-manual.com Sanyo Manuals