Sanyo PLC-XU115 User Manual

55
Setting
Change the PIN code lock setting
UsethePoint◄►buttonsto
switchbetweentheoptions.
UsethePoint◄►buttonstoselectOff,On1,orOn2and
then movethe pointer to “Quit” with the Point ▼ button.
PresstheSELECTbuttontoclosethedialogbox.
Change the PIN code lock setting
Enter a PIN code
Use the Point ▲▼ buttons to enter a number. Press the
Point►buttontofixthenumberandmovetheredframe
pointertothenextbox.Thenumberchangesto“.”Ifyou
fixedanincorrectnumber,usethePoint◄buttontomove
the pointer to the number you want to correct, and then
enterthecorrectnumber.
Repeatthissteptocompleteenteringafour-digitnumber.
After entering the four-digit number, move the pointer to
“Set.” Press the SELECTbutton so that you can start to
operatetheprojector.
IfyouenteredanincorrectPINcode,“PINcode”andthe
number () will turn red for a moment. Enter the
correctPINcodealloveragain.
Enter a PIN code
AfteracorrectPINcodeis
entered,thefollowingdialog
boxappears.
The PIN code can be changed to your desired four-
digit number. Press the Point ▼ button to select “PIN
code change” and press the SELECT button. The New
PINcodeinputdialogboxappears.SetanewPINcode.
Change the PIN code
Change the PIN code
CAUTION:
WHEN YOU HAVE CHANGED THE PIN CODE, WRITE
DOWN THE NEW PIN CODE IN COLUMN OF THE
PIN CODE NO. MEMO ON PAGE 76, AND KEEP IT
SECURELY. IF YOU FORGET YOUR PIN CODE, THE
PROJECTOR CAN NO LONGER BE STARTED.
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XU115 Specifications

General

Projection distance	0.93/11.47 m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-40 - 40 °
I/O ports	SD Card Slot
Audio input	1
Aspect ratio	4:3
Special features	Soft Carry Bag
Networking features	Ethernet & Wireless
F-number (relative aperture)	1.7
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Dot clock scanning frequency	140 MHz
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)	266 W

Weight and Dimensions

Package weight	3500 g