Sanyo PLC-XU115 User Manual

31
Computer Input
Choose Computer 1(Digital) by pressing the INPUT button
on the top control or press the COMPUTER button on the
remotecontrol.
Beforeusing these buttons,correctinput sourceshouldbe
selectedthroughMenuoperationasdescribedbelow.
PresstheMENUbuttontodisplaytheOn-ScreenMenu.
Use the Point ◄► buttons to move the red frame
pointertotheInputMenuicon.
1
Input Menu
Use the Point ▲▼ buttons to move the red arrow
pointer to Computer 1 (Digital), and then press the
SELECTbutton.
2
AftertheSourceSelectMenuappearedforComputer1
(Digital),movethepointertoRGB(PCdigital)orRGB
(AVHDCP),andthenpresstheSELECTbutton.
3
Input Source Selection (RGB(PC digital), RGB(AV HDCP))
Movethepointer(red
arrow)toComputer1
(Digital)andpressthe
SELECTbutton.
InputMenuicon
Movethe pointer to
the source that you
want to select and
press the SELECT
button.
Computer
1
Computer 1 (Analog)
Video
Computer 2
COMPUTER button
Wired
Top Control
INPUT button
Computer 1 (Digital)
Remote Control
Computer 1 (Analog)
Computer 2
Computer 1 (Digital)
Direct Operation
Menu Operation
Notes:
•HDCP (High-bandwidth Digital Content Protection) is
a system for protecting digital entertainment content
delivered by DVI (Digital Visual Interface) from being
copied. The specification of HDCP is decided and
controlledbyDigitalContentProtection,LLC.Shouldthe
specificationbechanged,thisprojectormaynotdisplay
thedigitalcontentprotectedbyHDCP.
 •Wired and Wireless are for the Network  function. See
owner’smanual“NetworkSet-upandOperation”.
 •WhentheInputSearchfunctionissetto“On1”or“On2”,
theinputsignalwillbesearchedautomatically(p.51).
Wireless
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XU115 Specifications

General

Projection distance	0.93/11.47 m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-40 - 40 °
I/O ports	SD Card Slot
Audio input	1
Aspect ratio	4:3
Special features	Soft Carry Bag
Networking features	Ethernet & Wireless
F-number (relative aperture)	1.7
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Dot clock scanning frequency	140 MHz
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)	266 W

Weight and Dimensions

Package weight	3500 g