Sanyo PLC-XU115 User Manual

30
Choose either Computer 1 (Analog) or Computer 2 by
pressing the INPUT button on the top control or press the
COMPUTERbuttonontheremotecontrol.
Beforeusing these buttons,correctinput sourceshouldbe
selectedthroughMenuoperationasdescribedbelow.
Press the MENU button to display the On-Screen
Menu. Use the Point ◄► buttons to move the red
framepointertotheInputMenuicon.
1
Input Menu
Use the Point ▲▼ buttons to move the red arrow
pointer toeither Computer 1 (Analog) or Computer 2,
andthenpresstheSELECTbutton.
2
When selecting Computer 1 (Analog), RGB input
sourcewillbeselecteddirectly.
When selecting Computer 2, the Source Select Menu
appears.MovethepointertoRGBandthenpressthe
SELECTbutton.
3
Computer 1 (Analog)
Video
Computer 2
Input Source Selection (RGB: Computer 1 (Analog)/Computer 2 )
Computer Input
Move the pointer (red
arrow) to Computer 1
(Analog)andpressthe
SELECTbutton.
InputMenuicon
COMPUTER button
Notes:
 •Wired and Wireless are for the Network function. See
owner’smanual“NetworkSet-upandOperation”.
 •WhentheInputSearchfunctionissetto“On1”or“On2”,
theinputsignalwillbesearchedautomatically(p.51).
Move the pointer
(redarrow)toRGB.
Move the pointer (red
arrow) to Computer 2
andpresstheSELECT
button.
InputMenuicon
Computer
2
Wired
Top Control
INPUT button
Computer 1 (Digital)
Remote Control
Computer 1 (Analog)
Computer 2
Computer 1 (Digital)
Direct Operation
Menu Operation
Input Menu
Wireless
Downloaded From projector-manual.com Sanyo Manuals

Sanyo PLC-XU115 Specifications

General

Projection distance	0.93/11.47 m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-40 - 40 °
I/O ports	SD Card Slot
Audio input	1
Aspect ratio	4:3
Special features	Soft Carry Bag
Networking features	Ethernet & Wireless
F-number (relative aperture)	1.7
Lamp type	NSH
Lamp power	275 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Dot clock scanning frequency	140 MHz
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (typical)	266 W

Weight and Dimensions

Package weight	3500 g