Sanyo SPW-C0705DZH8 - Page 101

:
:
:
I:
(HI)
(MED)
(LO)
1.
Cooling mode:
Heating mode:
()
2.
1)
2)
CAUTION
D:
E:
F:
G:
H: Temperature setting
buttons
FAN SPEED button
MODE button
Operation lamp
OFF button
ON button
J: FLAP button
This button is for turning the selected air conditioner on.
This button is for turning the selected air conditioner off.
This lamp lights when the unit is turned on.
Use this button to select one of the following 5 operations:
Used to automatically set cooling or heating operation.
Only for heat pump type
Only for heat pump type
: Used for normal heating operation.
Used for normal cooling operation.
:
Used for dehumidifying without changing the room temperature.
In the Cool mode and Dry mode, when the flaps are set in a
downward position, condensation may form and drip aroun
the vent.
Do not move the flap with your hands.
Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the ( ) symbol appears
on
the display.
This function is available only for models X, XM, K, T and L types.
The flap setting can be performed only for units that have no remote
controllers.
In the ALL or ZONE mode, no flap setting can be performed. If
necessary, you should select the GR mode and use the FLAP button.
3
5
5
3
Number of airflow direction settingsOperation mode
Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
: Low fan speed
: Medium fan speed
: High fan speed
: The air conditioner automatically decides the fan speed.
: Press this button to decrease the temperature setting.
: Press this button to increase the temperature setting.
(AUTO)
(FAN)
(COOL)
(DRY)
(HEAT)
(AUTO)
This function is available only for models X, XM, T and L types.
(FAN)
(DRY)(COOL) or
(HEAT) or
(AUTO)
Used to run the fan only, without heating or cooling operation.
When the indication is displayed, you cannot change the
mode from
and or to or and . To change the mode, turn off all
units once then select the mode again.
(Temperature range: 17 to 27°C)
(Temperature range: 16 to 26°C)
(Temperature range: 18 to 30°C)
(Temperature range: 18 to 30°C)
NOTE
NOTE
NOTE
NOTE
3-49
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
4. System Controller
TD831143-00W-3WAY.indb49TD831143-00W-3WAY.indb49 2008/12/0110:26:382008/12/0110:26:38