Sanyo SPW-C0705DZH8 - Setting up Programmed Operations

*1
Setting Up Programmed Operations
Example settings
The currently selected day of the week blinks slowly at
this time.
When the SET button is pressed, the program
schedule marker ( ) changes from blinking to
lighting and, at the same time, the time set in program
starts blinking. Also, the present time indication
changes to a blinking “PG-2”.
Press the DAY button and select a day of the week for
programmed operation.
STEP 2
The number of selectable groups is set during
installation.
Group selection is disabled depending on installation
conditions. If so, proceed to the next step.
Press the GROUP button to select a group for
programmed operation and then press the SET
button.
When the PROGRAM button is pressed, the group
No. and today’s day of the week start blinking and the
present time indication changes to a blinking “PG-1”.
Press the PROGRAM button to select a group.STEP 1
To change the settings of an existing program, use the same
procedure used to set up a new program as below.
A combination of the below operations can be set for each timer program.
–Air conditioner starting/stopping
–Remote controller operation enable/disable *1
Up to 6 programmed operations can be set per day for each group and day
of the week.
The remote controller operation enable/disable setting is disabled
depending on installation conditions. If so, appears on the display when
the button is pressed.
For more information, contact your dealer.
Correctly set the present time and today’s day of the week.
Unless both are correctly set, the programs will not run as expected.
NOTE
NOTE
3-74
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
5. Schedule Timer
TD831143-00W-3WAY.indb74TD831143-00W-3WAY.indb74 2008/12/0110:26:432008/12/0110:26:43