Sanyo SPW-C0705DZH8 - Address Switch Setting

After installation and adjust-
ment, be sure to turn the
BACK UP switch ON.
Gap
Coin
Gap
Address Switch Setting
To Installers,
All bits are set off
when shipped from
factory.
WARNING
To avoid an electric shock hazard,
DO NOT touch any terminal on the
Printed Circuit Board with a metal
rod, a screwdriver edge nor a bare
hand when power is supplied.
PCB of the control unit
Dip switches
How to reach the PCB
Remove the Machine screw on the bottom of the back case. When you
open up the decorative cover, you will see 2 notches under the control
unit. Inset a coin or other flat object into these notches and pry off the
back case. The PCB on the back of the control unit is now visible.
3-59
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
4. System Controller
TD831143-00W-3WAY.indb59TD831143-00W-3WAY.indb59 2008/12/0110:26:402008/12/0110:26:40