Sanyo SPW-C0705DZH8 - Accessories for Schedule Timer; Installing the Schedule Timer

(with current fuse) *1
T10 relay wire *2
Power wire for
connection to
system controller
1
2
3
4
5
6
7
8
1
1
1
2
2
6
1
1
Q'ty
Q'ty
Operation
manual
Wire joints
No.
No.
Supplied parts
Supplied parts
Spacers
Installation
manual
Machine screws
T10 power wire
Indoor unit control PCB
T10 connector (6P, yellow)
1. Power wire
2. Relay wire
4-series
type
3-series
type
Fig. 3-56
*1
*2
<Note 1>
<Note 2>
<Note 3>
(1)
(2)
(3)
(4)
Align the schedule timer unit with the tabs on the
back case and press to install it.
Connect the supplied power wire (2-core) and
inter-unit control wire (3-core) to the schedule
timer unit. (Refer to “Wiring the Schedule Timer.”)
Use the 2 supplied M4 machine screws and install
the schedule timer back case onto the switch box.
Before installing, use a screwdriver or similar tool
to press on and open the screw holes that corre-
spond to the JIS box that is used.
When fastening the case, use spacers and do not
tighten the screws too much. If the schedule timer
does not fit tightly against the wall, cut the spacers
as required to make adjustments.
Open the panel on the schedule timer unit. Insert
a standard (flat-head) screwdriver or similar tool
into the notches on the bottom of the schedule
timer unit to open and remove the back case.
Install a noise filter or take other appropri-
ate action if electrical noise affects the
power supply circuit of the unit.
Install the schedule timer at a location
away from any sources of electrical noise.
Avoid twisting the inter-unit control wiring
or the input/output wiring together with
power or other wiring, and avoid running
them in the same metal conduit. Doing so
can cause malfunction.
Installing the Schedule Timer
Use with 3-series type (Fig. 3-56).
If the fuse blows as a result of a wiring short-cir-
cuit, miswiring, or overcurrent, replace it with a
125 V, 0.1 A fuse.
Accessories for Schedule Timer
M4 × 30
Fig. 3-57
M4 x 25 machine
flat-head screws (2)
Spacer
Under-case
(back case)
JIS C8340
Switch box for 1 switch (no cover)
or switch box for 2 switches (no cover)
Decorative
cover (panel)
Schedule
timer unit
3-88
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
5. Schedule Timer
TD831143-00W-3WAY.indb88TD831143-00W-3WAY.indb88 2008/12/0110:26:472008/12/0110:26:47