Sanyo SPW-C0705DZH8 - Setting Errors; If Program Times Are the same

If time is set as shown below while setting up a program, “ERROR” is displayed (the indication blinks).
Therefore, correct the time setting.
Setting Errors
If Program Times are the Same
Every time the SET button is pressed, the setting mode switches between programmed operations of
the same time setting ( and in the above example), therefore select the time setting to correct.
Change the time setting with the HH and MM buttons so that the times are no longer the same.
Press the SET button and check “ERROR” is not displayed.
Press the PROGRAM button to end the setting mode.STEP 4
STEP 3
STEP 2
STEP 1
Example of Time Settings That Do Not Cause Errors
The below time settings do not generate an error.
1) When ON and OFF times are staggered 2) When OFF time is earlier than ON time
3-76
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
5. Schedule Timer
TD831143-00W-3WAY.indb76TD831143-00W-3WAY.indb76 2008/12/0110:26:442008/12/0110:26:44