Sanyo SPW-C0705DZH8 - Zone Registration Using the System Controller (SHA-KC64 AGB); Automatic Zone Registration Using the System Controller (SHA-KC64 AGB)

(b)
(2)
(3)
(4)
(6)
(7)
Fig. 3-52
Fig. 3-53
(c)
(1)
(2)
(3) All registerd GROUP Nos. will disappear.
(4)
(5)
(6)
If no data is
registered
no number
is displayed.
Selected
group No. if
no data is
registered.
If data is
registered
the unit No.
is displayed.
For example, in the case at left
Zone 3, group No. 7
Unit No. (indoor unit address) 2-8
Unit No. 2-8 is registered to zone 3-group 7.
Fig. 3-54
Finally, complete automatic zone registration
mode by pressing the button.
flashes for a few minutes, then goes OFF.
If an error occurs “CHECK” starts flashing and
zone registration finishes at this time.
Press the button.
Central addresses will be assigned from small
indoor unit addresses to large addresses in
numerical order automatically.
After automatic zone registration is completed,
changes from flashing to OFF.
Select CODE. No. C2 by pressing and
( ) button and press the button.
C2 changes from flashing to ON state and
automatic zone registration will start.
Press the and buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
Automatic zone registration using the system
controller (SHA-KC64AGB)
Finally, complete the registration by pressing
the button.
flashes for a few minutes, then goes OFF.
Register the other UNIT Nos. in the same way by
following the steps (3) to (5).
GROUP No. turns ON and UNIT No. (Indoor unit
address) changes from flashing to ON state.
UNIT No. is registered to selected ZONE No.
and GROUP No.
If you make a mistake, then press the button
and reselect the ZONE, GROUP and UNIT No.
Press the button.(5)
button
button
Indoor unit No..................
R.C. No...........................
Set the unit No. (Indoor unit address) with
and buttons, according to the zone
registration table.
Select the zone and group No. which you want to
set with and (GROUP)
buttons. If already set, press the button.
After confirming that CODE No. C1 is displayed,
press the button. Once in this mode,
a change takes place as Fig. 3-52.
Press the and buttons at the same
time for more than 4 seconds.
and CODE No. C1 will flash.
(1)
Zone registration using the system controller (SHA-KC64AGB)
In this case, you set all Central addresses by
system controller at once manually.
3-66
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
4. System Controller
TD831143-00W-3WAY.indb66TD831143-00W-3WAY.indb66 2008/12/0110:26:422008/12/0110:26:42