Sanyo SPW-C0705DZH8 - Page 103

Description
A:
B:
C:
D:
E:
F:
G:
H:
I:
J:
K:
A
B
C
D
E
F
G
H
I
J
K
Display
When the unit is in heating standby status, the indicator appears.
The currently selected operation mode is displayed.
The currently selected FAN SPEED, Airflow Direction and SWEEP settings are
displayed.
This indication appears when the filter needs cleaning.
This indication appears only when an abnormality occurs within a unit.
The currently selected mode (ALL, ZONE or GROUP), ZONE number and GROUP
number are displayed.
GROUP number display (no figure: no number registered)
GROUP state display ( : registered group, : currently selected
group)
Operation state display ( : on, no sign: off, : alarm)
The currently selected central control mode (1, 2, 3 or 4) is displayed.
Lights when any of the air conditioners under the system control is operating; turns off
when none of the air conditioners under the system control is operating. Blinks when
any conditioner is operating under abnormal conditions and its protection function
is working.
When the button is pressed for more than 4 seconds, the TEST indicator
appears.
This indication appears when the temperature is set.
When turning on the power switch of the system controller, sign blinks for a few
minutes. While blinking, any controls using the system controller are inhibited. This is
because the system controller is verifying connected groups.
3-51
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
4. System Controller
TD831143-00W-3WAY.indb51TD831143-00W-3WAY.indb51 2008/12/0110:26:382008/12/0110:26:38