Sanyo SPW-C0705DZH8 - Page 231

256
120
480
480
400
60
250
70
73
30
15
30
160
80 160
160
347
45
113
514
514
88
88
382
35
840
840 950
950
X
790
188
97
120
210
9
53
7
2 2 1 2
10
8
7
8
2
4
6
97
723
1 2 3 4 5 6 7 8 9
10
* The length of the suspension
bolts should be selected so that there is a gap of 30 mm or more below the lower surface of the ceiling (15 mm or more below the lower surface of the main unit), as shown in the figure at right. If the suspension bolt is too long, it will contact the ceiling panel and the unit cannot be installed.
Ceiling opening dimensions
Suspension bolt pitch
Ceiling opening dimensions
Suspension bolt pitch
Center of panel
Less than 35
Less than 35
X View
860 – 910
860 – 910
Air intake Discharge outlet Refrigerant tubing (narrow tube) 7-18 type ø6.35 (flared), 25 type ø9.52 (flared) Refrigerant tubing (wide tube) 7-18 type ø12.7 (flared), 25 type ø15.88 (flared) Drain tube connection port VP25 (outer dia. ø32) Power supply port Discharge duct connection port (ø150) Vaporizing-type humidifier (optional) installation point Suspension bolt hole (4-12 × 37 hole) Fresh air intake duct connection port (ø100)
4-73
1
2
3
4
5
6
7
8
3-WAY ECO-i SYSTEM Unit Specifi cations
2. 4-Way Air Discharge Semi-concealed Type (X, XM Types)
2-3. Dimensional Data
Indoor unit: SPW-XDR74 / 94 / 124 / 164 / 184 / 254GXH56(A/B)
SPW-X075 / 095 / 125 / 165 / 185 / 255XH
TD831143-00W-3WAY.indb73TD831143-00W-3WAY.indb73 2008/12/0117:23:162008/12/0117:23:16