Operating Instructions Combics Indicators 141
Menu Structure
Combics 1 Application Menu
*= Factory settings
Applic. WEIGH.
param.1
min.init Minimum load for automatic taring 3.5
1-digit 1 digit* 3.5.1
2-digit 2 digits 3.5.2
5-digit 5 digits 3.5.3
10-dig. 10 digits 3.5.4
20-dig. 20 digits 3.5.5
50-dig. 50 digits 3.5.6
100-dI. 100 digits 3.5.7
200-dI. 200 digits 3.5.8
500-dI. 500 digits 3.5.9
1000-d 1000 digits 3.5.10
aut.tare Automatic taring: fi rst weight tared 3.7
OFF Off 3.7.1
ON On 3.7.2
TARE.FNC Tare function 3.25
normal Can add a preset tare if tare value is available;
however no tare function possible 3.25.1*
special When a preset tare is entered, the tare value is deleted;
however, tare function activation is possible 3.25.2
RESET Restore all applications to factory default settings 9.1
YES Yes (restore factory settings) E9.1.1
NO No (retain user-defined settings) 9.1.2*
Combics 2 Application Menu
*= Factory settings
Applic./Applic.1 WEIGH. Weighing
min.init Minimum load for automatic taring 3.5
1-digit 1 digit 3.5.1*
2-digit 2 digits 3.5.2
5-digit 5 digits 3.5.3
10-dig. 10 digits 3.5.4
20-dig. 20 digits 3.5.5
50-dig. 50 digits 3.5.6
100-dI. 100 digits 3.5.7
200-dI. 200 digits 3.5.8
500-dI. 500 digits 3.5.9
1000-d 1000 digits 3.5.10
aut.tare Automatic taring: fi rst weight tared 3.7
OFF Off 3.7.1
ON On 3.7.2
Applic./Applic.1 Count. Counting
min.init Minimum load for application 3.6
1-digit 1 digit 3.6.1*
2-digit 2 digits 3.6.2
... see “Weighing"
1000-d 1000 digits 3.6.10
RESOLUT Resolution for calculation of reference piece weight 3.9
DISP.ACC Display accuracy 3.9.1*
10 FOLD plus 1 decimal place (10 fold) 3.9.2
100 FOLD plus 2 decimal places (100 fold) 3.9.3
SAVE WT. Parameter for saving weight values 3.11
STABIL. With stability 3.11.1*
ACC.STAB With increased stability 3.11.2
REF.UPDT Reference sample updating 3.12
OFF Off 3.12.1
AUTOMAT Automatic 3.12.2*
To Next Page
Loading...
Need help?
General
