Example: Using the Counting application with a stored average piece weight.
Confi guration: Application: Counting (COUNT.)
Saving the average piece weight
§ Start the application.
t Determine the average piece weight using one of the methods described above.
t Enter the memory cell number using the keypad, and press and hold the R key
(min 2 seconds).
Loading the average piece weight or reference sample quantity
t Enter the memory cell number and press the I key.
– Use the k key to switch between wRef (average piece weight) and nRef
(quantity).
– Use the ) key to scroll the displayed value to the right.
– Use the R key to activate the displayed memory.
– Press and hold the c key (min. 2 seconds) to delete the displayed memory.
t Exit the mode using the c key.
Overwriting data in a memory cell
t Enter the memory cell number to be overwritten via the keypad.
t Press and hold the R key (min 2 seconds).
y The previous average piece weight is overwritten.
t To cancel without saving, press the c key.
Deleting an average piece weight
t Enter the memory cell number of the average piece weight to be overwritten.
t Press the I key.
t Delete the displayed value by pressing and holding the c key (min. 2 seconds) .
Operation
To Next Page
Loading...
Need help?
General
