Operators Handbook DCU3 – System
14., Supplement
BAEDCU3 - Rev. 4.6 - 0504 14 - 8
14.5 Fermentor - Specific Adjustments of Balance Systems
Each balance system will have its own specific documentation. The configuration informa-
tion will be included herein or be delivered separately with the device, when the balance is
part of the entire fermentor system. Below you will find the necessary settings for the menus
for balance operation. The documentation for customized adjustment can also be attached
herein or be delivered extra with the equipment.
Balance system, made by SARTORIUS
Section in the manual
of the balance
Function Setting for DCU
Services Data output condition Single print without hold (stop)
no data designation
Weight units weight unit
see configuration documents
Interface Parameters Baud rate
see configuration documents
Parity
see configuration documents
number of stop bits
see configuration documents
type of handshake software handshake
Miscellaneous beeper off
ISO Calibration off
Balance system, made by METTLER, with RS232 interface
Configuration menu of
balance system
Function Setting for DCU
I-FACE Data transfer mode all
Baud rate
see configuration documents
Pause 0
calibration note Au to on
UNIT weighing unit
see configuration documents
Balance system, made by METTLER, with LocalCAN Bus interface
Switch position of
universal interface
Position of rotary knob Meaning
left hand 7 Alternate
middle 5 9600 Baud
right hand 3 7 Bit, Even, SI
If you miss specific information concerning your special equipment, please contact your lo-
cal representative of Sartorius BBI Systems GmbH for further support or write directly Dept.
Automation of Sartorius BBI Systems GmbH, see address given in the next section.
To Next Page
Loading...