Operators Handbook DCU3 – System
8., Main Function „Recipes“
BAEDCU3 - Rev. 4.6 - 0504 8 - 5
8.5 Timers in Recipes
You can also activate all configured timers via the recipe. All timers can be started simultaneously
while a recipe is loaded. For this the timers must be set to „start“ in the recipe. If a timer should not be
started when the recipe is loaded, they must be set to „no change“ in the recipe.
8.5.1 Operating Display
Tag Entry Displayed value or function, required input
MODE Additional state of timer for recipe
----- (no change): recipe does not effect the timer
8.5.2 Special Notes
Detailed information about the timers is included in section 6.22, Timers
Timers that should not be affected by the recipes, must be set to „no change“ in the recipe.
Then the current parameters are not overwritten after the recipe is loaded.
If the timers should be processed immediately after the recipe is loaded, they must be set to
„start“ in the recipe.
In the „Mode: profile“ the breakpoint of a timer profile must have at least one time different
from zero.
In „Mode: cycle“ a timer must have a time for „CYCLE“ and „PULSE“. Otherwise the profile
cannot be started.
To Next Page
Loading...