Sartorius DCU 3 - Controller Parameters in Recipes

Operators Handbook DCU3 – System
8., Main Function „Recipes“
BAEDCU3 - Rev. 4.6 - 0504 8 - 3
8.3 Controller Parameters in Recipes
For all configured controllers you can specify and store the controller parameters „setpoints“, „control-
ler modes“ or „controller outputs“ in recipes. Inputs will be made similar to those in the main function
„Control Loops“. If a controller should not be controlled via the recipe, you can switch over the mode
for this controller to „no change“ during input of the recipe parameters.
8.3.1 Operating Display (Example for Temperature Controller)
Tag Entry Displayed value or function, required input
MODE Additional input of controller mode for recipe
-----
(no change) recipe does not effect the controller
8.3.2 Special Notes
 See the chapter „Main Function Control Loops“ for a detailed description of the controllers.
 Controllers that should not be changed by the recipe, must be set into „no change“ mode.
Then the current parameters will not be overwritten when a recipe is started.