Operators Handbook DCU3 – System
8., Main Function „Recipes“
BAEDCU3 - Rev. 4.6 - 0504 8 - 4
8.4 Setpoint Profiles
In recipes you can specify setpoint profiles for all configured controllers. Inputs will be made similar to
those within the main function „Parameters“. When a recipe is loaded all profiles can be started simul-
taneously, if they all are set to „start“ in the recipe.
8.4.1 Operating Display (Example for Temperature Controller)
Tag Entry Displayed value or function, required input
MODE Additional input of state of profile for recipe
----- Setpoint profile will not be effected by the recipe
8.4.2 Special Notes
See also detailed descriptions of profiles in chapter 6.21, Setpoint Profiles
If a profile should be processed immediately after the recipe is loaded, set the MODE to
„start“ during input of the recipe.
If a recipe should not effect a profile, the MODE „-----“ (no change) must be entered.
The breakpoint of a profile must have at least one time setting different from zero. Otherwise
the profile cannot be started.
To Next Page
Loading...