Sartorius DCU 3 - Controller Selection and Display

Operators Handbook DCU3 – System
6., Main function „Control Loops“
BAEDCU3 - Rev. 4.6 - 0504 6 - 2
6.2 Selection of Controller
6.2.1 Operating Display
Tag Entry Displayed value or function, required input
PV [PV] Display of actual process value, entry (= physical unit) depending on
process value
SETP [PV] input of setpoint, entry (= physical unit) depending on process value
MODE input of controller mode
off
− master controller and servo controller switched off
auto
− master controller switched on, servo controller switched to „cascade“
manual
− manual access to controller output
prof
− timer profile for setpoint
TEMP, etc. selection of controller display
TIMER selection of timer for digital output
CLOOP selection of the controller menu