Operators Handbook DCU3 – System
5., Main Function „Calibration“
BAEDCU3 - Rev. 4.6 - 0504 5 - 7
5.5.2 Calibration
For calibration of the turbidimetry sensor proceed as follows.
1. Start the calibration via „Start Calibration“
2. Follow the instructions of the calibration menu.
5.5.3 Special Notes
1. If the lamp
1)
is switched on, it will be kept in „on“-state when the DCU3 - system is switched
off and on again.
2. If required, the percentage zero deviation can directly be entered in the ZERO-entry.
To Next Page
Loading...