Sartorius DCU 3 - Page 47

Operators Handbook DCU3 – System
6., Main function „Control Loops“
BAEDCU3 - Rev. 4.6 - 0504 6 - 13
6.10.1 Operating Display pO
2
- Cascade Controller
 For a description of the tags, the physical units or entries, the displayed value or function
and of the required inputs see the table in section 6.3, Controller Operation in General.
 Additional functions of this Operating Display are the following:
Tag Entry Displayed value or function, required input
CASCADE Input of servo controller for sequential cascade control
STIRR
− stirrer speed controller
AIRFL
− airflow controller (if installed)
GASMIX
− gasmix controller
OUT [Controller] % Display of the controller output for the active servo controller
during sequential cascade control, with actual controller output