12
Fastening an Antitheft Locking Device
$ Models FC06BBE-S, FC6CCE-H, FC2CCE-S, FC12CCE-S,
and FC6CCE-S only.
To fasten an antitheft locking device, use the lug located on the rear panel
of the scale.
● Secure the scale at the place of installation, e.g., with a chain
or a lock.
Leveling the Scale
Purpose:
– To compensate for unevenness at the place of installation
– To achieve perfectly horizontal positioning of the scale for consistent
reproducibility
Always level the scale again any time it is moved.
Models FC06BBE-S, FC6CCE-H, FC2CCE-S, FC12CCE-S, and FC6CCE-S:
Only the 2 front feet are used for leveling.
● Turn the 2 front feet as shown in the illustration until the air bubble
is centered within the circle of the level indicator
> Several leveling steps are usually required.
● When weighing heavy samples (or when the YDH 01 LP display arm
is attached):
Retract the 2 rear feet until they touch the surface on which the
scale rests
Models FC34EDE-P, FC16EDE-S, FC12EDE-P, and FC64EDE-S:
● Adjust the three leveling feet until the air bubble is centered within the
circle of the level indicator
Setting the Language
> See the “Setting the Language” section in the chapter entitled
“Configuring the Scale”
Setting the Date and Time
> See the “Entering User Data” section in the chapter entitled
“Configuring the Scale”
To Next Page
Loading...
