Operating the Scale
65
Time-Controlled Functions K
Purpose
With this application program, you
can configure the scale to perform
certain functions (e.g., automatic
printout of values, store value in
totalization memory) at a given time
or after a set interval.
You can use this application program
in combination with a program
chosen from Application 1 (e.g.,
counting, weighing in percent) and
one from Application 3 (e.g.,
totalizing, formulation).
Available Features
– Time-controlled triggering of
scale functions:
– one time only, at a given time
(Setting= is displayed in
the text line)
– repeatedly, at given intervals
(Interval= is displayed in
the text line before the function
is started, and
Repeat = is displayed after
the function is started)
– Functions that can be time-
controlled include:
– Acoustic signal
– Lock in readout
– Automatic printout of values
– Store values for totalizing,
formulation or statistics
– Print time in addition to
weight value
– Store value independent
of stability
– Tare the scale after printout
of weight values
– Press the corresponding soft key
to cancel time-controlled functions
Factory Settings
Function after time interval:
Automatic printout
of values
Automatic function restart: On
Storage mode:
Without stability
Print then tare: On
Soft Key Functions
Stop Stop the application
Quit Confirm performed
function (e.g., “Lock in
readout” or “Beep”)
Interv Store input interval for
time-controlled functions
Set. Store input time for
one-time performance
of function