Operating the Scale
77
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing,
you can also access the following
functions from this application:
– calibration (not during alpha-
numeric input or initialization),
– toggling to another application
(e.g., counting),
– setup,
– turning off the scale.
Calibration/Adjustment
§ Press the isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to Another Application
§ Press D/[TOGGLE]
> See the section on the
corresponding application
program for further instructions
Setup (setting parameters)
§ Press M
> See “Configuring the Scale”
for further instructions
Turning Off the Scale
§ Press e/[ON/OFF]
> The scale shuts off
> The display goes blank
Preparation
§ Turn on the scale: Press e
> Sartorius logo is displayed, self-test is performed
§ Select the Statistics application program in the Setup menu: Press M
§ Select the Application menu: App soft key
§ Select Application 3: Press the q soft key twice and then press O
§ Select Statistics: Q or q soft key
§ Confirm Statistics: O soft key
§ Select and confirm:
– Automatic storage:
Off or
On, first value at stability or
On, last value at stability or
On, value bet. 70-130% at stabil.
– Minimum load for automatic storage:
None or
10 digits or
20 digits or
50 digits or
100 digits or
200 digits or
500 digits or
1000 digits
– Source of data for auto storage:
Application 1 or
Application 2
– Evaluated values:
Net or
Calculated or
Net + calculated
– Evaluation mode, MR function:
Intermediate evaluation, print or
Final evaluation, print or
Intermediate eval., display+print or
Final evaluation, display+print
– M+/M- function, then tare:
Off or
On
– Printout of individual components:
No or
Yes
see also the “Application Menu (Overview)” in the chapter entitled
“Configuring the Scale”
§ Save settings and exit the Setup menu: Press M
To Next Page
Loading...
