72
Formulation M
Purpose
With this application program you
can add weight values and
calculated values to a totalization
memory as components of a formula.
You can use this application program
in combination with a program
chosen from Application 1 (e.g.,
counting, weighing in percent) and
one from Application 2 (check-
weighing, time-controlled functions).
Available Features
– Totalization of weight values and
calculated values
– Simultaneous storage of net and
calculated values
– Optional configuration in the
Setup menu for loading weight
values and calculated values
either from Application 1 (e.g.,
counting, weighing in percent)
or from Application 2 (check-
weighing, time-controlled
functions)
– Totalization memory for up to
65535 values
– Transaction counter and current
total displayed in the text line
– Scale tared after a value
is stored
– Manual input of the number of
individual weighing operations
(enter on the numeric and press
nDef). Result printed and
memory cleared when number
entered has been reached
– Optional configuration in the
Setup menu to add the current
weight, with display accuracy,
to the current total by pressing
the M+ soft key and generating
a printout of the result
– Optional configuration in the
Setup menu for stability-depen-
dent storage of the measured
value: Stability range
– Optional automatic storage of
measured values
Storage of measured value is
indicated by
Uu.
zz indicates that you can place
a load on the scale.
– Minimum load threshold for
automatic storage
– Press the
M- soft key to delete
the last value added to the
totalization memory.
The transaction counter value
is reduced by one and a printout
is generated.
– Printout of an evaluation of
results, depending on the
Application 1 or Application 2
parameters. Configure the Setup
menu to define the information
included on this printout.
– Press MR for a printout of an
intermediate evaluation after each
addition or a final evaluation
– Optional configuration in the
Setup menu to clear the
totalization memory and reset
the transaction counter by
pressing c or after an evalua-
tion is printed out
– Totalization data and transaction
counter data are stored in non-
volatile memory
– Continue formulation after turning
the scale off and back on
Factory Settings
Automatic storage:
Off
Minimum load for automatic storage:
10 digits
Source of data for auto storage:
Application 1
Evaluated values: Net
Evaluation mode, MR key function:
Intermediate
evaluation, print
Printout of individual components:
On
Stability range:
1-3-4 2 increments
Tare after individual printout: No
Soft Key Functions
M+ Add weight values or
application values to the
total in the totalization
memory. The component
or transaction counter
value increases by one
each time you press
this key.
M- Delete the last value
added to memory. The
transaction counter value
decreases by 1. You
cannot delete previous
values by repeatedly
pressing this key.
MR Print or display an
intermediate or final
evaluation
nDef Store the input number
of components
To Next Page
Loading...
Need help?
General