Operating the Scale
73
Preparation
§ Turn on the scale: Press e/[ON/OFF]
> Sartorius logo is displayed, self-test is performed
§ Select the Formulation application program in the Setup menu: Press M
§ Select the Application menu: App soft key
§ Select Application 3: Press the q soft key twice and then press O
§ Select Formulation: Q or q soft key
§ Confirm Formulation: O soft key
§ Select and confirm:
– Automatic storage:
Off or
On, first value at stability.
– Minimum load for automatic storage:
None or
10 digits or
20 digits or
50 digits or
100 digits or
200 digits or
500 digits or
1000 digits
– Source of data for auto storage:
Application 1 or
Application 2
– Evaluated values:
Net or
Calculated or
Net + calculated
– Evaluation mode, MR function:
Intermediate eval., print or
Final evaluation, print
– Printout of individual components:
No or
Yes
see also the “Application Menu (Overview)” in the chapter entitled
“Configuring the Scale”
§ Save settings and exit the Setup menu: Press M
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing,
you can also access the following
functions from this application:
– calibration (not during alpha-
numeric input or initialization),
– toggling to another application
(e.g., counting),
– setup,
– turning off the scale.
Calibration/Adjustment
§ Press the isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to Another Application
§ Press D/[TOGGLE]
> See the section on the
corresponding application
program for further instructions
Setup (setting parameters)
§ Press M
> See “Configuring the Scale”
for further instructions
Turning Off the Scale
§ Press e/[ON/OFF]
> The scale shuts off
> The display goes blank
To Next Page
Loading...
Need help?
General