15
Configuring the Scale
Practical Example 1:
Enter “Workstation 234” as scale ID; display and print other user data
Step Key (or instruction) Display/Output
1. Select Setup:Input Press M, then
Display workstation ID the Input soft key
(in this example: no ID assigned)
2. Before entering letters – Press a
3. Select the letters group Press the STUVWX
soft key
4. Set the letter “M” Press the W soft key
5. Enter the next letters of the – Press the MNOPQR
scale ID soft key
6. Set the letter “e” Press the O soft key
7. Repeat steps 5 and 6 to enter Soft key ...
the required letters
8. Enter the numbers 234 2 3 4
If the last character entered
is a letter:
Conclude input of letters a
9. Store scale ID Press the l soft key
To Next Page
Loading...
