58
Preparation
§ Turn on the scale: Press e
> Sartorius logo is displayed, self-test is performed
§ Select the Calculation application program in the Setup menu: Press M
§ Select the Application menu: App soft key
§ Select Application 1: O soft key
§ Select Calculation: Q or q soft key repeatedly
§ Confirm Calculation: O soft key
§ Select and confirm:
– Decimal places in calculated result:
None or
1 decimal place or
2 decimal places or
3 decimal places or
4 decimal places or
5 decimal places or
6 decimal places
see also the “Application Menu (Overview)” in the chapter entitled
“Configuring the Scale”
§ Save settings and exit the Setup menu: Press M
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing,
you can also access the following
functions from this application:
– calibration (not during
alphanumeric input),
– toggling to the next application
(e.g., checkweighing),
– setup,
– turning off the scale.
Calibration/Adjustment
§ Press the isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to the Next Application
§ Press D/[TOGGLE]
> See the section on the
corresponding application
program for further instructions
Setup (setting parameters)
§ Press M
> See “Configuring the Scale”
for further instructions
Turning Off the Scale
§ Press e/[ON/OFF]
> The scale shuts off
> The display goes blank
To Next Page
Loading...
Need help?
General