Connecting the Balance to AC Power
The balance is energized by a power supply/AC
adapter. Make sure that the voltage rating printed
on this unit is identical to your local line voltage.
If the voltage specified on the label or the plug design
of the power supply/AC adapter does not match
the rating or standard you use, please contact your
Sartorius office or dealer.
Important Note:
Use only original Sartorius power supplies/AC
adapters. Use of power supplies/AC adapters from
other manufacturers, even if these units have
an approval identification marking from a national
testing laboratory, requires the consent
of an authorized Sartorius service technician.
Detailed information on additional options
for powering the balance is available in our service
information bulletin, no.15/88 (for example,
using local extra-low voltage).
Plug the cord of the AC adapter/power supply into
the DC jack on the rear panel of the
balance/computing device. Then insert the plug
of
the power supply or the AC adapter into a wall outlet.
1–13
To Next Page
Loading...
