Press either l or r to close the draft shield
automatically by motor. While closing, the interior
draft shield door moves slowly. The previously
adjusted aperture angle is stored.
If you press either l or r once again, the draft
shield door will open at a faster speed to the position
you have selected. Press l or r for approx.
2 seconds to open the draft shield door
automatically
as far as it will go (170°).
You can always change the aperture angle
by manually adjusting the position of the draft
shield door.
Important Note
The aperture angle remains stored even after you
have turned off the display by pressing e.
A stored aperture setting will not be erased until
you unplug the balance from AC power.
Manual Mode
Of course, you can also open and close the draft
shield door by hand.
1–22
To Next Page
Loading...
