Data Printout/Record for Application Programs (menu code 8 10 3)
For application programs, the reference data (parameters) can be included
in the printout/record.
Automatic output of the reference data (parameters) Code
Off 7 1 1*
Reference %/qty. and reference weight 7 1 2
Reference weight only 7 1 3
You can also add the reference data to the printout/record later by pressing i
(information function), p and then either the f or F key.
To have data printed out, perform the following:
– Press the f or F key to output the printout heading and reference data
(the reference data will be stored at the same time)
or
– Press the p key to output the printout heading and the first value
If you input and store new references while an ISO/GLP-compliant record is being
printed out, the new reference data will be output. If you enter different data
before generation of an ISO/GLP-compliant record is started, the printout heading
and the reference data will automatically be printed once you press p. Then
the measured value will be output.
– Press p to output weighing data
– Press the c key to end printout generation (generation of an ISO/GLP-compliant
printout also ends once a calibration or linearization operation has been started)
– Then press the c key to clear the reference data for the application programs
During data printout, the print symbol P appears on the display of the balance.
* = factory setting
2–28
To Next Page