Satec PM180 - 5 PIXIT - Protocol Implementation Extra Information for Testing; Device Configuration; ACSI Models; Association Model

32
5 PIXIT - Protocol Implementation Extra
Information for Testing
This chapter describes device specific implementation of the protocol and communication
capabilities of the PM180.
5.1 Device configuration
The device configuration except of the listed items cannot be modified and is listed for
information only.
5.2 ACSI models
Association model
Item Value/Comments
Maximum simultaneous client associations 4
TCP Keepalive 120-600 s, configurable
Authentication Not supported
Association parameters
TSEL 0001, fixed value
SSEL 0001, fixed value
PSEL 00000001, fixed value
AP-Title Not required, ignored if present
AE-Qualifier Not required, ignored if present
Maximum MMS PDU size 16000
Typical startup time after a power supply interrupt 5 s
Server model
Item Value/Comments
Quality bits for analog values (MX)
Validity Good
OutofRange Not supported
Failure Not supported
Inconsistent Not supported
Source Process
Other quality bits and values Not supported
Quality bits for status values (ST)
Validity Good
BadReference Not supported
Failure Not supported
Inconsistent Not supported
Inaccurate Not supported
Source Process
Other quality bits and values Not supported
Maximum number of data values in Get/SetDataValues
requests
Limited only by the MMS PDU size
Setting group model
Item Value/Comments
Number of setting groups Not supported