Satel INTEGRA Plus - [Code]# Arming and Disarming Menu

SATEL INTEGRA Plus 9
3 short beeps – signaling of:
– starting the procedure of arming (there is exit delay in the partition) or arming (there is
no exit delay in the partition),
– disarming and/or alarm clearing,
– turning output off,
– turning off the CHIME in the keypad, using the 8 key,
– toggling the display between the standby mode and the partition status presentation
mode, using the 9 key,
– exiting the function and returning to the menu after confirmation of the data entered.
4 short beeps and 1 long beep – signaling of:
– turning output on,
– turning on the CHIME in the keypad, using the 8 key,
– ending the function and exiting the user menu after confirmation of the data entered.
1 long beep – signaling of:
– violated/ bypassed zones when arming,
– fault of the vibration detector (10. 24H VIBRATION type zone was not violated during the
vibration detector test run upon starting the arming procedure).
2 long beeps – invalid code/card, function not available or exiting the function without
confirmation of the data entered (e.g. by using the key).
3 long beeps – unavailable function.
Events signaled by sounds
Only installer selected events are signaled.
Alarms are being signaled throughout the time programmed by the installer.
5 short beeps – zone violation (CHIME).
Long beep every 3 seconds, followed by a series of short beeps for 10 seconds
and 1 long beep – countdown of exit delay (if the time is shorter than 10 seconds, only
the final sequence of short beeps will be generated).
A sequence of 7 beeps of diminishing duration, repeated every few seconds –
countdown of auto-arming delay.
2 short beeps every seconds – countdown of entry delay.
2 short beeps every 3 seconds – signaling a new trouble.
Continuous beep – alarm.
Long beep every second – fire alarm.
5.2 [Code] – arming / disarming menu
Information given in the section below do not apply to users having the SIMPLE USER
right (see p. 25).
After you enter the code and confirm it with the
key
:
– a message on the need to change the code or a service note may be displayed,
– alarm will be cleared – if the user is authorized to clear the alarm and there is an alarm
in the system,
– one partition will be disarmed – if the user is authorized to disarm the partition, has
access to only one partition operated from the keypad and that partition is armed, or has
access to many partitions, but only one partition is armed,