Satel INTEGRA Plus - 6.2 Functions available from the partition keypad

SATEL INTEGRA Plus 37
3 short beeps – signaling of:
– starting the procedure of arming (there is exit delay in the partition) or arming (there is
no exit delay in the partition),
– disarming and/or alarm clearing.
4 short and 1 long beeps – confirmation that the function has been executed.
3 pairs of short beeps – the user should change his/her code.
1 long beep – refusal to arm (there are violated zones in the partition or there is a trouble).
2 long beeps – unknown code/card.
3 long beeps – unavailable function.
Events signaled by sounds
Only installer selected events are signaled.
Alarms are signaled for the time programmed by the installer.
5 short beeps – zone violation (CHIME).
Long beep every 3 seconds, followed by a series of short beeps for 10 seconds
and 1 long beep – countdown of exit delay (if the time is shorter than 10 seconds, only
the final sequence of short beeps will be generated).
A sequence of 7 beeps of diminishing duration, repeated every few seconds –
countdown of auto-arming delay.
2 short beeps every second – countdown of entry delay.
Continuous beep – alarm.
Long beeps every 2 seconds – alarm memory.
Long beep every second – fire alarm.
Short beeps every 2 seconds – fire alarm memory.
Very short beeps – door open too long.
6.2 Functions available from the partition keypad
6.2.1 [Code]
Depending on the user type and authority level, keypad settings and the alarm system status,
entering the code and confirming with the
key will execute one or a few of the following
functions:
 unlocking the door (activating the relay),
 disarming the partition,
 clearing alarm,
 changing over the status of 25. BI SWITCH type outputs,
 turning on the 24. MONO SWITCH type outputs,
 guard round confirmation,
 enabling temporary partition blocking.
Most of the abovementioned functions are available after enabling the LOCK [LOCK
FEATURE] option for the partition keypad. Whether the functions are available may also
depend on the other keypad options (e.g. if the lock operates in the ON IF PARTITION
ARMED [ON IF PART.ARMED] mode, most of the functions will be unavailable).