22 User Manual SATEL
If the user can only arm one partition, the arming procedure will be initiated as soon as
the code is entered and confirmed with the key.
5.4.2 Full arming the selected partitions
1. Enter the code and confirm with the
key.
2. Using the key, scroll through the menu until you find the ARM function.
3. Press the
key. A list of partitions which can be armed will be displayed.
4. Using the and keys, find in the list the partition which is to be armed (or press 0 key
and enter the partition number).
5. Press one of the digit keys 1 to 9. The symbol in the upper right-hand corner will be
replaced by the symbol (see also “Selection from the multiple-choice list” p. 15).
6. Repeat the steps 4 and 5 for the next partitions which are to be armed.
7. Having selected the partitions which are to be armed, press the
key.
You can also arm the selected partitions using of the ARM SELECTED function, available upon
entering the code and confirming with the
key, but only when none of the partitions
accessible to you is armed and the keypad is signaling no alarm.
5.4.3 Arming in the selected mode
1. Enter the code and confirm with the
key.
2. Using the key, scroll through the menu until the ARMING MODE function is found.
3. Press the
key. A list of arming modes will be displayed (see: description of the ARMING
MODE
function, p. 16).
4. Using the and keys, find the arming mode which is to be activated, and then press
the
key.
5. When the ARM function is displayed, press the
key. Proceed in the same way, as for
the full arming of selected partitions (steps 4-7).
5.4.4 Quick arming
The installer can permit the arming without user authorization. The partitions indicated by the
installer will be armed.
1. Select the arming mode (press one of the keys: 0 – full arming; 1 – full arming +
bypasses; 2 – arming without interior; 3 – arming without interior and without entry delay).
2. Press the key. The arming procedure will begin.
5.4.5 Denial of arming
The installer can program the control panel so that the arming procedure could not be
started, if:
– a zone is violated in the partition,
– there is a trouble in the system (including tamper),
– there was a verified alarm.
The keypad will inform you about the refusal to arm by means of a message specifying the
cause for refusal.
If after a verified alarm the arming is impossible, the installer must be called. The
arming will only be possible after the installer intervention (see: description of the
SYSTEM RESET function, p. 16).
To Next Page
Loading...
