Satel INTEGRA Plus - Keyfob Operation and Audio Verification; 10.3 Audio alarm verification; 11. Operating the alarm system by means of keyfob

SATEL INTEGRA Plus 43
2. Within up to 15 seconds, pr
beeps and 1 long beep will c
ess in turn the 2 and # keys on the telephone keypad. 4 short
onfirm that you have got access to the telephone control
as
function.
Within u3. p to 15 seconds, enter the 2-digit number of the remote switch (e.g. 01, 07 or 15).
The control panel will inform you about the switch status change by means of sounds:
3 short beeps – the switch has been turned off,
4 short and 1 long beeps – the switch has been turned on.
The operating mode of the REMOTE SWITCH type output depends on how the output h
been configured by the installer.
4. keypad, the control panel will
an e 1 and #
un
Upon pressing in turn the 0 and # keys on the telephone
g up. You can also press th keys to return to the phone call answering
ction.
h
f
10.3 Audio alarm verification
Remote audio alarm verification is possible when the INT-AV module is connected to
the control panel.
1. Get access to the phone call answering function (steps 1-2 in section “Answering phone
al
Within up to 15 seconds, press in turn
beeps and 1 long beep will confirm that you have got access to the function of audible
are described in the INT-AV module manual.
ls”).
the 3 and # keys on the telephone keypad. 4 short
c
2.
alarm verification. The DTMF commands you can use after starting the listen-in / talk
session
11. Operating the alarm system by means of keyfob
In the case of a control panel to which the ACU-120, ACU-270, ACU-100, ACU-250, INT-RX
– bidirectional APT-100 keyfob – supported by the ABAX system (ACU-120, ACU-270,
igned (see: “Adding
or INT-RX-S module is connected, you can control the system using the keyfob. The user
can have up to 2 keyfobs:
ACU-100 (firmware version 2.00 or newer) or ACU-250 controller),
– 433 MHz keyfob – supported by the INT-RX or INT-RX-S module.
One keyfob enables execution of up to 6 functions. For each keyfob, functions to be executed
upon pressing a button / combination of buttons, and for the APT-100 bi-directional keyfobs
also information to be displayed on the keyfob LEDs, are individually ass
keyfob” p. 28).