Satel INTEGRA Plus - Communication and Verification Features; 10.1 Answering phone calls; 10.2 Telephone control

42 User Manual SATEL
 allow to get access to the INT-VG module voice menu.
10. Call answering and telephone control
The information below does not apply to the control panels to which the INT-VG
module is connected.
The call answering and telephone control functions are available to the users who have the
ph
answering function allows to get information on the partition status (armed, disarmed). Owing
one code. These functions require that the DTMF dialing phone be used. The call tele
to the telephone control function, it is possible to control the REMOTE SWITCH type outputs
using the telephone.
10.1 Answering phone calls
1. Establish connection with the control panel, using one of the following methods (consult
is supported by the control panel):
umber of control panel. The control panel will answer the
after the number of
2. En
con nswering function. If the entered code is
eps.
the installer to learn which method
single call – call the telephone n
call after the number of rings programmed by the installer.
double call – call the telephone number of control panel. Hang up
rings programmed by the installer. Call again within three minutes. The call will be
answered by the control panel immediately.
Establishing connection will be signaled by three short beeps.
ter the telephone code on the telephone keypad. 4 short beeps and 1 long beep will
firm that you have got access to the call a
invalid, this will be signaled by the control panel by two long be
If you make a mistake when entering the code, enter the 4 digits anyway, and when
the control panel signals that the code is wrong, enter the correct code.
After entering three wrong codes, the control panel will hang up.
In case of a single call, if:
 no code has been entered and the connection is terminated,
 an invalid code has been entered and the connection is terminated,
the control panel will answer no calls for the next few minutes. It enables e.g.
a fax to
be connected after the control panel.
3. Within up to 15 seconds, enter the 2-digit partition number (e.g. 01, 07 or 15). The control
up.
4. keys on the telephone keypad, the control panel will
panel will inform you about the partition status by means of sound signals:
3 short beeps – partition disarmed,
4 short and 1 long beeps – partition armed.
If no key is pressed on the phone for 15 seconds, the control panel will hang
Upon pressing in turn the 0 and #
hang up.
10.2 Telephone control
1. Get access to the phone call answering function (steps 1-2 in section “Answering phone
calls”).