Satel INTEGRA Plus - Starting Functions and Data Entry

SATEL INTEGRA Plus 13
Perm.DLOADX acc enable/disable permanent DLOADX access
DLOADX IP set address of computer with DLOADX program
GUARDX IP set address of computer with GUARDX program
Erase s.message erase service note
Tests
Partitions check current state of partitions
Zones check current state of zones
Supply voltages check module supply voltage
Radio devices check radio signal level for wireless devices
Temperatures check temperatures measured by ATD-100 detectors
Zones test
New
Burglary zones start new test for burglary zones
Fire/tech.zones start new test for fire and technical zones
One zone start new test for single zone
View results
view test results
Finish test
abort test
Clear results clear test results
Battery test test battery and 60. TECHN. - BATTERY LOW zones
Manual tr. test start manual test transmission
Station 1A test start test transmission to station 1 – main phone number
Station 1B test start test transmission to station 1 – backup phone number
Station 2A test start test transmission to station 2 – main phone number
Station 2B test start test transmission to station 2 – backup phone number
Messaging test start messaging test
Answering test display information on answered tel. call
Prox. card test check proximity card number
CA-64 PTSA test start mimic board test
View masters view master users
Keypad name display keypad name
File in DLOADX display inf. on DLOADX program file with control panel data
Panel version display information on control panel firmware version
STM prg.version
display information on the STM processor program version
IP/MAC ETHM-1 disp. inf. on ETHM-1 / ETHM-1 Plus module IP and MAC address
Modules version
display information on module firmware version
Time synchron.
start time synchronization
Service access set installer access time
Open door open selected door controlled by system
Outs control
control outputs
Service mode start service mode
Take SM over take over service mode
Downloading
Start DWNL-RS start local programming
Finish DWNL-RS finish local programming
Start DWNL-MOD. start communication via external modem
Start DWNL-TEL start communication via 300 bps modem
ETHM-1 – DLOADX start communication via Ethernet with DLOADX program
ETHM-1 – GUARDX start communication via Ethernet with GUARDX program
5.3.2 Starting functions
1. Using the  and  keys, find the required submenu or function. The currently selected
submenu or function is indicated by the arrow ( ) on the left-hand side.